If the Quick Arm feature is disabled, you will manage to arm and disarm the panel only when using the correct user code. Note that if the Quick Arm feature is enabled in the programming settings of DSC panels, the app can arm the panel even with the wrong pin code but you cannot disarm it. To test the app, arm and disarm the panel. You’re now at the partition screen where you can perform various actions on your alarm system. This should take no longer than 60 seconds. The security app is just retrieving information from the panel. This is the code you use to arm and disarm your panel on the keypad. Tap on “Scan QR Code” and scan the QR Code found on the sticker at the back of the Falcon.Įnter your user code. Once you’ve completed all the steps on this screen, tap “Continue.” Enter a password that is secure but one that you will remember and tap submit.Īfter reading through this notification, tap “OK.” Scroll through the welcome screens by tapping the arrow and select “Get Started.” Tap “Sign Up” and enter your personal details to create an account. Search for the security app by name and tap “Install”. To connect the panel to the security app, go to your phone’s app store. No programming is needed for the panel to work with the security app.
#Dsc alarm panel shows open serial
Connect the Falcon to the DSC Neo panel through the serial port (PC LINK 2) using the serial cable and adapter marked 'DSC Neo'' provided. Make sure that the Falcon unit has a firmware version of 4.13 or later.
#Dsc alarm panel shows open how to
The Falcon will remember the new serial port format.įor the module to determine which zones belong to which partition, you need to fully arm all partitions and trigger every zone ensuring that each event is sent through to control room. The following video will show you how to set up a Falcon GSM communicator to work with a DSC Neo panel. Push the button to cycle through the panel serial port format options until you reach the DSC PowerSeries format, indicated by a small letter “b”.
To do this, remove power from the Falcon, hold down the push-button and re-apply power. Set the serial port format on the Falcon unit to DSC PowerSeries.
Wire the DSC PowerSeries FSK Key-bus Module to the keypad-bus on the alarm panel and then connect the 4-pin molex connector to the serial port of the Falcon. Make sure that the Falcon unit has a firmware version of 4.19 or later. The following video will show you how to set up a Falcon GSM communicator to work with a DSC Power panel.